Instruction Manual Model 1582-10M Protection Switch January 2009 Rev O MENUEXECUTEMODEL 1582SWITCHCROSS TECHNOLOGIES
2.4 Menu Settings2.4.1 FunctionsThis section describes operation of the front panel controls. There are three ope rator switches, the LCD display an
2.5 Power On SettingsNOTE: THE LAST STATUS OF A UNIT IS RETAINED EVEN WHEN POWER IS REMOVED. WHEN POWER IS RESTORED, THE UNIT WILL RETURN TO IT&a
2.5.3 Alarm IndicationsON POWER UPNORMAL DISPLAYPUSHING MENU/EXECUTE SEQUENCEREV 1.00OUTPUT = CH1MANUAL SELECTOFFSCROLL <>SCROLL PUSH BUTTO
2.6 Use InformationA. Elevated operating ambient temperature - if installed in a closed or multi-unit rack assembly, the operating ambient temperatur
CROSS TECHNOLOGIES, INC.6170 Shiloh RoadAlpharetta, Georgia 30005(770) 886-8005FAX (770) 886-7964Toll Free 888-900-5588WEB www.crosstechnologies.com E
INSTRUCTION MANUALMODEL 1582-10M PROTECTION SWITCH TABLE OF CONTENTS PAGEWarranty 21.0 General 31.1 Equipment Desc
MODEL 1582-10M Protection Switch1.0 General1.1 Equipment Description - The 1582-10M 1:1 Switch, 10 MHz provides Auto, Manual or Remote relay switchi
1.2 Technical Specifications1582-10M Technical SpecificationsSwitch CharacteristicsImpedance 75 ohmsType Non-latching RelayIsolation >50 d
1.3 Monitor and Control InterfaceA) Remote serial interfaceProtocol: RS-232C, 9600 baud rate, no parity, 8 data bits, 1 start bit, and 1 stop bit.(R
1.4 M&C CommandsThe following tables summarize the commands and status queries applicable to the 1582-10M Protection Switch. * PLEASE NOTE: The
Table 2.2 Model 1582-10M - M&C Status Commands - Continued y = 2 if switch mode is Manual y = 1 if switch mode is Remote y = 0 if switch mode is
2.0 Installation2.1 Mechanical - The 1582-10M is rack mounted by attaching the front panel to a rack through the four holesat the edges of the panel
2.3 Installation / Operation2.3.1 Installing and Operating the 1582-10M, Protection Switch Section1. Connect primary 10 MHz signal to CH1 In/out, J1
Comments to this Manuals