Instruction Manual Model 1582-14 Data Switch June 2009 Rev. A SWITCH A MODEL 1582POWER1 2 AUTO CROSS TECHNOLOGIES,
2.6 Switch Mode Setup - The following gives the switch mode settings of the on board controls that can be changed in the field: SWITCH A JP1, JP2, JP
2.8 Environmental Use InformationA. Rack-Mounting - To mount this equipment in a rack, please refer to the installation instructions located in the u
CROSS TECHNOLOGIES, INC.6170 Shiloh RoadAlpharetta, Georgia 30005(770) 886-8005FAX (770) 886-7964Toll Free 888-900-5588WEB: www.crosstechnologies.com
INSTRUCTION MANUALMODEL 1582-14 DATA SWITCH TABLE OF CONTENTS PAGEWarranty 21.0 General 31.1 Equipment Descrip
MODEL 1582-14 Data Switch1.0 General1.1 Equipment Description - The 1582-14 Data Switch has two independent switches (A and B) in a single 1 3/4” ch
1.2 Technical SpecificationsTABLE 1.0 1582-14 Data Switch Specifications*Data CharacteristicsInput/Output RS422Data rate 128 kbps, maxConnectors, da
2.0 Installation2.1 Mechanical - The 1582-14 is rack mounted by attaching the front panel to a rack through the four holes at the edges of the panel
2.3 Front Panel Controls and Indicators - The following are the front panel controls and indicators.SWITCH APOWER1 2 AUTO ON-LINEMANUALSELECTR
2.4 PC Board Settings2.4.1 On-Card JumpersNOTE: Dot position means jumper goes from center pin to the pin nearest the dot on the PCB. Also the first
JP10, JP110 - CH1 Clock Detection Filter- 3-pin jumper that filters out non-data spikes if clock is not present.Non-dot position - presence of cloc
2.5 Time Out Alarm Settings - Switches S4 (CH2, SWITCH A), S5 (CH1, SWITCH A), S104 (CH2, SWITCH B), and S105 (CH1, SWITCH B) determine the length of
Comments to this Manuals