Cross Technologies 2015-24 Instruction Manual

Instruction Manual Model 2015-24 Upconverter May 2013, Rev. G MENUEXECUTEMODEL 2015CROSS TECHNOLOGIES INC.F=1525.000G=+

2.3 Front Panel Controls and Indicators Figure 2.3 shows the front panel controls and indicators.LCD DISPLAYDisplay shows frequency in MHz and Gain i

2.4 Installation / Operation2.4.1 Installing and Operating the 2015-24 Upconverter1. Connect a -40 dBm to -10 dBm, 140 MHz signal to IF IN, J4 (Fig

2.5 Menu Settings2.5.1 Functions - This section describes operation of the front panel controls. There are three operator switches, the LCD display

2.5.2. Power On SettingsNOTE: The last status of a unit is retained even when power is removed. When power is restored, the unit will return to it&

2.5.4 Frequency ChangesAt any time during the modification process, if you have made a mistake and do not wish to save the changes you have made, d

2.5.5 Gain ChangesWhen you get to this menu note that the gain changes will be made as you make them but if you do not wish to save the changes you h

2.5.5 Alarm IndicationsAn alarm condition for will occur if the local oscillator phase lock loop (PLL) comes out of lock. The Mute LED will light if

3.0 Environmental Use InformationA. Rack-Mounting - To mount this equipment in a rack, please refer to the installation instructions located in the u

CROSS TECHNOLOGIES, INC.6170 Shiloh RoadAlpharetta, Georgia 30005(770) 886-8005FAX (770) 886-7964Toll Free 888-900-5588WEB www.crosstechnologies.com

INSTRUCTION MANUALMODEL 2015-24 Upconverter TABLE OF CONTENTS PAGEWarranty 21.0 General 31.1 Equipment Description 31.2 Technical Characteristics 4

MODEL 2015-24 Upconverter1.0 General1.1 Equipment DescriptionThe 2015-24 L-band Upconverter converts 140 ± 36 MHz to 950 to 2150 MHz in 1kHz, 10kHz,

1.2 Technical CharacteristicsTABLE 1.1 2015-24 Upconverter Specifications*Input Characteristics (IF)Impedance 75 ΩReturn Loss 18 dBFrequency 1

1.3 Monitor and Control InterfaceA) Remote Serial InterfaceProtocol - RS-485, RS-422 or RS-232C (selectable), 9600 baud rate, no parity, 8 data bits,

B) Status RequestsTable 1.2 lists the status requests for the 2015-24 and briefly describes them.* PLEASE NOTE: The two character {aa}(00-31) prefix,

C) Commands Table 1.3 lists the commands for the 2015-24 and briefly describes them. After a command is sent the 2015-24 sends a return “>” indic

2.0 Installation2.1 Mechanical The 2015-24 consists of one RF/Controller PCB which is housed in a 1 RU (1 3/4 inch high) by 16 inch deep chassis. A

2.2 Rear Panel Input / Output Signals Figure 2.2 shows the input and output connectors on the rear panel.ACGNDJ1810 MHZ REFOUTPUTAC1 - POWER INAC in